Your water heater is one of the used and much more costly appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating and costs.
Regular flushing of one’s water heater are probably the single most important step you can take to prolong its service life and to save energy. Over a period of time, sediments enhance in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most involving the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double daily life of your water heater from 3-5 to 7-10 years. To provide a source costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater ‘s very important in today’s affordable. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.
To drain your water heater, first you should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located more than a water inlet line going into your water heater. After backing up connect a hose to the drain valve located towards the bottom of the heater. Open the drain and allow it working out until all of your water has emptied from the hot water heater. Then close the drain. Open the water supply valve and refill the central heater. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until water flows out gradually. This will allow air to vent off of the heater and the hot water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas possess hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and merchandise to be fitting.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX